Advanced Setup Menu - CEA DIGITECH vision PULSE Series Operator's Manual

ADVANCED SETUP Menu

ENCODER K
To access the ADVANCED SETUP Menu from any point on the control panel:
• Open the SETUP Menu by holding the SX K
• Open the CONFIG Menu by rotating the ENCODER K
• Access the ADVANCED CONFIGURATION function by rotating the ENCODER K
ENCODER K - DX.
NOB
• Access the ADVANCED WELDING MODE function by rotating the ENCODER K
CODER K - DX.
NOB
• Access the PLANT CONFIGURATION function by rotating the ENCODER K
ER K - DX.
NOB
• Exit the CONFIG Menu by pushing the MENU K
• At this stage the SETUP Menu has been transformed into the ADVANCED SETUP Menu and the VISION S
following additional icons:
- ADVANCED CONFIG
- ADVANCED MODE
- EQUIPMENT LAYOUT
- WELD LOG
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
WARNING:
• It is impossible to weld!
• If the VISION S
is protected by a password, access to this menu will only be allowed by entering the correct password.
CREEN
It is not possible to access the ADVANCED SETUP Menu and all the related sub-menus using the "HT4" control panel.
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
down for at least 5 consecutive seconds.
EY
NOB
.
EY
Used to exit the ADVANCED SETUP Menu and take the VISION S
welding phase.
Used to scroll the various icons (sub-menus) in the menu and then select them.
Used to access the menu related to the icon selected.
ACCESSING THE SUB-MENUS
To access the sub-menus included in the ADVANCED SETUP Menu, you must:
• Turn the ENCODER K - SX to select the desired icon.
NOB
• Push the ENTER/MEM K .
EY
"HT4" CONTROL PANEL
SETUP
- SX until the icon required is reached, and then push the ENTER/MEM K
NOB
- SX and select ACTIVATE by rotating the ENCOD-
NOB
67
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
- SX and select ACTIVATE by rotating the
NOB
- SX and select ACTIVATE by rotating the EN-
CREEN
.
EY
displays the
CREEN
back to the