Job; Creating And Saving / Editing And Overwriting A Job - CEA DIGITECH vision PULSE Series Operator's Manual

JOB

1 - Creating and saving / editing and overwriting a JOB

ENCODER K
PRG JOB PROCESS I
001 MMA 97
002 --- --- ---
003 --- --- ---
004 --- --- ---
005 --- --- ---
011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
PRG JOB PROCESS I
001 MMA 97
002 0011 MIG/MAG SYNERGIC 211
003 --- --- ---
004 --- --- ---
005 --- --- ---
011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
A V
211 24.8
002
PROGRAM 0011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
PRG JOB PROCESS I
001 MMA 97
002 0011 MIG/MAG SYNERGIC 211
003 --- --- ---
004 --- --- ---
005 --- --- ---
OVERWRITE JOB 002?
It is not possible to create, save, edit or overwrite a JOB using the "HT4" control panel.
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
CREATING AND SAVING A JOB
To create and save a JOB (automatic welding point) proceed as follows:
• During any welding process and at any time, once you have acquired the necessary parameters, hold
the ENTER/MEM K down for 3 consecutive seconds.
EY
• The VISION S
automatically goes to the first free position in the JOB table.
CREEN
• Choose the position in which the JOB is to be saved by rotating the ENCODER K
• Push the ENTER/MEM K
EY
EDITING AND OVERWRITING A JOB
To edit and/or overwrite a JOB proceed as follows:
• During any welding process and at any time push the MENU K
• Select the welding process JOB by rotating the ENCODER K
• Push the MENU K
to open the JOB table.
EY
• Select the JOB to be edited by rotating the ENCODER K
• Push the ENTER/MEM K
EY
• Hold down the ENTER/MEM K
parameters / data for the JOB onto the screen (making them available to the operator).
• Acquire the parameters necessary for editing the JOB.
• Hold down the ENTER/MEM K
• The VISION S
automatically goes to the first free position in the JOB table.
CREEN
• Choose the free position in which the edited JOB is to be saved, or a position already occupied in
which the edited JOB will be overwritten, by rotating the ENCODER K
• Push the ENTER/MEM K
EY
• Push the SX K to confirm the overwriting operation or the DX K
EY
"HT4" CONTROL PANEL
A V
211 24.8
PROGRAM 0011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
to confirm and finalise saving of the JOB created.
to view the settings on the VISION S
for about 3 consecutive seconds, until the VISION S
EY
for 3 3 consecutive seconds.
EY
to confirm the operation.
49
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
NOB
to exit the welding phase.
EY
- SX.
NOB
- SX.
NOB
for the JOB to be edited.
CREEN
CREEN
- SX.
NOB
to cancel it.
EY
JOB
- SX.
loads all the