Setup Menu - CEA DIGITECH vision PULSE Series Operator's Manual

PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER DISPLAY S
CREEN
In the case of an Automatically reset error once the alarm condition has ended (reinstatement completed correctly), the weld-
ing plant is once again ready and the operator can recommence welding! The alarm state disappears and the VISION S
turns to precisely the same point at which it was operating previously.
PLEASE NOTE: After resetting has been completed, during normal operation of the machine, the VISION S
error signal to inform the operator of the event (
K
. WARNING: This only removes the visual error indication but not the history of what happened!
EY
In the case of NON automatically reset errors, to remove the alarm status and reinstate correct operation of the machine, the
welding plant must be switched off.
When it is switched on again, the machine will be working again and the operator can weld again!
PLEASE NOTE: If, when switching on, the error status presents itself again, immediately contact Technical Assistance
Department.

SETUP Menu

To access the SETUP Menu hold down for at least 5 consecutive seconds the SX K
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
WARNING:
• It is impossible to weld!
• If the VISION S
is protected by a password, access to this menu will only be allowed by entering the correct password.
CREEN
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
- A Displays the error message (e.g. Err.).
Shows the alarm code (e.g. E1.0) of in succession, the codes for the alarms in succession if
- V
there are a number of errors.
), but this can be removed visually from the display by simply pushing the MENU
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to exit the SETUP Menu and take the VISION S
Used to scroll the various icons (sub-menus) in the menu and then select them.
Used to access the menu related to the icon selected.
HOLD Function LED
PARAMETER DISPLAY S
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
ENCODER K
GAS K
SPECIAL FUNCTIONS (F
SPECIAL FUNCTIONS (F
.
EY
SETUP
55
- V
CREEN
- V
EY
- V
NOB
EY
) K
X EY
) LED
X
will still show the
CREEN
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
back to the entry phase.
CREEN
re-
CREEN