Hold - CEA DIGITECH vision PULSE Series Operator's Manual

6 - HOLD

When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as HOLD. In this phase the VISION S
panel the HOLD F LED flashes until the end of the HOLD Function. If the HOLD Function is Interrupted via a panel (e.g. DH),
UNCTION
it will also be interrupted automatically on the other (HT4) and vice-versa.
ENCODER K
MENU K
EY
SX K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
EY
ENCODER K - A
NOB
WIRE K
EY
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) interrupting the HOLD
Function and subsequent menus, as applicable.
Scrolls in succession THICKNESS OF WELDED ITEM (
- WIRE SPEED (
released).
In this case the values displayed are those for: HOLD.
Adjusts the parameter selected using the SX K
If held down for 3 consecutive seconds, it interrupts the HOLD Function and makes it
possible to access SAVE JOB.
Scrolls in succession ARC LENGTH ADJUSTMENT (
ELECTRONIC INDUCTANCE (
the key is released).
In this case the values displayed are those for: HOLD.
Adjusts the parameter selected using the DX K
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
- A Shows the parameter indicated by the PARAMETER SELECTION LED - A.
The LED unit shows the welding parameter selected using the PARAMETER SELECTION K
Scrolls in succession THICKNESS OF WELDED ITEM (
- A
WIRE SPEED (
In this case the values displayed are those for: HOLD.
Adjusts the parameter displayed by the PARAMETER DISPLAY S
Function.
Activates loading of the wire without interrupting the HOLD Function.
shows the HOLD box highlighted, while on the HT4
CREEN
A V
86 25.9
PROGRAM 0203
CrNi Ø 1.2 98Ar2CO2
) only on the VISION S
CREEN
) only on the VISION S
) only on panel HT4.
31
MIG-MAG synergic
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
) - WELDING CURRENT ( )
(this operation is activated when the key is
interrupting the HOLD Function.
EY
) - WELDING VOLTAGE ( ) -
(this operation is activated when
CREEN
interrupting the HOLD Function.
EY
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
) - WELDING CURRENT ( ) -
- A interrupting the HOLD
CREEN
- V
- V
EY
EY
- A.
EY
(continued)