CEA DIGITECH vision PULSE Series Operator's Manual page 51

The SPECIAL FUNCTIONS (Fx) related to the Synergic MIG-MAG process correspond as follows to those on the wire feeder:
Special function
PRE GAS
STARTING SPEED
HOT START
STITCH TIME
STITCH PAUSE
SPOT TIME
INITIAL CURRENT
INITIAL ARC LENGTH
INITIAL CRATER TIME
INITIAL SLOPE
FINAL SLOPE
FINAL CURRENT
FINAL ARC LENGTH
FINAL CRATER TIME
BURN BACK
POST GAS
FIRST SLOPE ( I TO I )
1 2
CYCLE CURRENT
CYCLE ARC LENGTH
SECOND SLOPE ( I TO I )
2 1
ACS / ENCODER SPEED
WARNING:
• The STANDARD or ADVANCED welding CYCLE mode can only be activated by opening the ADVANCED SETUP Menu - AD-
VANCED MODE - CYCLE (for further explanations, see the relevant paragraph).
• (*) This SPECIAL FUNCTION is only to be found if the ADVANCED CRATER function has been activated by accessing the AD-
VANCED SETUP Menu - ADVANCED MODE - CRATER - ADVANCED (for further explanations, see the relevant paragraph).
• It is possible to access editing of the SPECIAL FUNCTIONS (Fx) during welding.
• Some of the values edited will be used immediately by the operator, while others will be active from when the next welding
task begins.
• The HOLD function is not active within the SPECIAL FUNCTIONS Menu (SET UP Fx).
PARAMETER DISPLAY Screen - V
PARAMETER DISPLAY
Screen - A
PrG
StS
Hot
F05
F06
F07
F08
F09
F10
F11
F12
F13 -30%
F14
F15
bub
PoG
F18 0.05s
F19
F20
F21 0.05s
F28 100A/s
0.1s (0.0 - 2.0)s
0 -30 - +30
0 -30 - +30
1.0s (0.1 - 8.0)s
1.0s (0.1 - 8.0)s
3.0s (0.1 - 20.0)s
20% -50% - +100%
0 -30 - +30
1.0s (0.0 - 5.0)s
1.0s (0.0 - 5.0)s
1.0s (0.0 - 8.0)s
-100% - +50%
0 -30 - +30
0.0s (0.0 - 5.0)s
0 -30 - +30
1.0s (0.0 - 10.0)s
(0.0 - 1.0)s
20% -99% - +100%
0 -30 - +30
(0.0 - 1.0)s
(5 - 500)A/s
27
Welding mode
● ● ● ● ●
● ● ● ● ●
● ● ● ● ●
●
● ●
● (*) ● (*)
●
● ●
● ●
● ●
● (*) ● (*)
●
● ● ● ● ●
● ● ● ● ●
● ● ● ● ●
● ● ●
● ● ●
● ● ●
●
●
● ●
● (*) ● (*)
● ●
● ●
● ●
● (*) ● (*)
● ● ●
● ● ●
●
● ●
● ●
●
● ● ●