CEA DIGITECH vision PULSE Series Operator's Manual page 61

ENCODER K - SX
NOB
DX K
EY
ENCODER K - DX
NOB
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
EY
ENCODER K - A
NOB
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
SPECIAL FUNCTIONS (F ) K
X EY
Adjusts the WIRE SPEED (
adjusted).
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
Scrolls in succession WELDING VOLTAGE ( ) - ELECTRONIC INDUCTANCE (
the VISION S
CREEN
In this case, where possible, the values displayed will be those measured.
Adjusts the parameter selected using the DX K
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
Shows the value (measured, if possible) for the parameter indicated by the PARAMETER
- A
SELECTION LED - A.
The LED unit shows the welding parameter selected using the PARAMETER SELECTION K
Scrolls in succession WELDING CURRENT ( ) - WIRE SPEED (
In this case, where possible, the values displayed will be those measured.
- A
When welding is in progress the WELDING CURRENT ( ) is displayed continuously until
this key is pushed.
Adjusts the WIRE SPEED (
adjusted).
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
The LED unit indicates the welding mode selected according to the VISION S
Shows the value (measured, if possible) for the parameter indicated by the PARAMETER
- V
SELECTION LED - V.
The LED unit indicates the welding parameter selected using the PARAMETER SELECTION K
- V.
Scrolls in succession WELDING VOLTAGE ( ) - ELECTRONIC INDUCTANCE (
- V
In this case, where possible, the values displayed will be those measured.
Adjusts the parameter displayed by the PARAMETER DISPLAY S
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT4 panel and not on the DH panel.
) parameter (the WELDING CURRENT ( ) cannot be
.
) parameter (the WELDING CURRENT ( ) cannot be
37
.
EY
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
) only on the HT4 panel.
- V.
CREEN
) only on
- V
- V
EY
EY
- A.
EY
.
CREEN
EY
).