Hold - CEA DIGITECH vision PULSE Series Operator's Manual

6 - HOLD

When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as HOLD. In this phase the VISION S
panel the HOLD F LED flashes until the end of the HOLD Function. If the HOLD Function is Interrupted via a panel (e.g. DH),
UNCTION
it will also be interrupted automatically on the other (HT4) and vice-versa.
ENCODER K
MENU K
EY
SX K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) interrupting the HOLD
Function and subsequent menus, as applicable.
Scrolls in succession THICKNESS OF WELDED ITEM (
- WIRE SPEED (
released).
In this case the values displayed are those for: HOLD.
Adjusts the parameter selected using the SX K
If held down for 3 consecutive seconds, it interrupts the HOLD Function and makes it
possible to access SAVE JOB.
Scrolls in succession ARC LENGTH ADJUSTMENT (
ELECTRONIC INDUCTANCE (
the key is released).
In this case the values displayed are those for: HOLD.
Adjusts the parameter selected using the DX K
shows the HOLD box highlighted, while on the HT4
CREEN
A V
217 29.4
PROGRAM 1011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
) only on the VISION S
CREEN
) only on the VISION S
14
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
) - WELDING CURRENT ( )
(this operation is activated when the key is
interrupting the HOLD Function.
EY
) - WELDING VOLTAGE ( ) -
(this operation is activated when
CREEN
interrupting the HOLD Function.
EY
MIG pulse