Hold - CEA DIGITECH vision PULSE Series Operator's Manual

4 - HOLD

When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as HOLD. In this phase the VISION S
panel the HOLD F LED flashes until the end of the HOLD Function. If the HOLD Function is Interrupted via a panel (e.g. DH),
UNCTION
it will also be interrupted automatically on the other (HT4) and vice-versa.
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - A
HOLD F LED
UNCTION
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
SPECIAL FUNCTIONS (F ) K
X EY
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) interrupting the HOLD
Function and subsequent menus, as applicable.
Adjusts the WELDING CURRENT ( ) parameter, interrupting the HOLD Function.
If held down for 3 consecutive seconds, it interrupts the HOLD Function and makes it
possible to access SAVE JOB.
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
- A
Displays the value of the parameter WELDING CURRENT ( ).
The LED unit shows the WELDING CURRENT ( ) switched on.
Flashes for a set time, informing the operator that the HOLD Function is active.
- V
Displays the value of the parameter WELDING VOLTAGE ( ).
The LED unit shows the WELDING VOLTAGE ( ) switched on.
Only enables entering, interrupting the HOLD Function and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP Fx) on the HT4 panel and not on the DH panel.
shows the HOLD box highlighted, while on the HT4
CREEN
A V
39 1.2
48
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
TIG LIFT
- V
- V
EY