Hold - CEA DIGITECH vision PULSE Series Operator's Manual

5 - HOLD

When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as HOLD. In this phase the VISION S
panel the HOLD F LED flashes until the end of the HOLD Function. If the HOLD Function is Interrupted via a panel (e.g. DH),
UNCTION
it will also be interrupted automatically on the other (HT4) and vice-versa.
WARNING: All the parameters saved within a JOB (including SPECIAL FUNCTIONS (Fx)) can be viewed but not edited!
ENCODER K
MENU K
EY
SX K
EY
ENTER/MEM K
EY
DX K
EY
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
EY
WIRE K
EY
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) interrupting the HOLD
Function and subsequent menus, as applicable.
Scrolls the active parameters in succession, only on the VISION S
welding process saved in the JOB selected.
If held down for 3 consecutive seconds, it interrupts the HOLD Function and makes it
possible to access SAVE JOB.
Scrolls the active parameters in succession, only on the VISION S
welding process saved in the JOB selected.
In this case the values displayed are those for: HOLD.
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
Shows the JOB term or value of the parameter indicated by the PARAMETER SELECTION LED -
- A
A.
The LED unit shows the welding parameter selected using the PARAMETER SELECTION K
Scrolls the active parameters in succession, based on the type of welding process saved in
- A
the JOB selected.
In this case the values displayed are those for: HOLD.
Activates loading of the wire without interrupting the HOLD Function.
shows the HOLD box highlighted, while on the HT4
CREEN
V
m/min
11.1 33.3
013
53
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
, based on the type of
CREEN
, based on the type of
CREEN
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
JOB
- V
- V
EY
- A.
EY
(continued)