Welding - CEA DIGITECH vision PULSE Series Operator's Manual

ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X EY

5 - WELDING

When welding takes place the fields in the displays show the same values as those included for pre-setting with the difference
that now, if possible, they are those measured.
ENCODER K
MENU K
EY
SX K
EY
ENCODER K - SX
NOB
DX K
EY
ENCODER K - DX
NOB
Adjusts the parameter displayed by the PARAMETER DISPLAY S
Activates the flow of gas.
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT4 panel and not on the DH panel.
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
Scrolls in succession THICKNESS OF WELDED ITEM (
- WIRE SPEED (
released).
In this case, where possible, the values displayed will be those measured.
Adjusts the parameter selected using the SX K
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
Scrolls in succession ARC LENGTH ADJUSTMENT (
ELECTRONIC INDUCTANCE (
the key is released).
In this case, where possible, the values displayed will be those measured.
Adjusts the parameter selected using the DX K
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
A V
217 29.4
PROGRAM 2011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
) only on the VISION S
CREEN
) only on the VISION S
21
- V.
CREEN
MIG dual pulse
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
) - WELDING CURRENT ( )
(this operation is activated when the key is
.
EY
) - WELDING VOLTAGE ( ) -
(this operation is activated when
CREEN
.
EY