Advanced Mode - CEA DIGITECH vision PULSE Series Operator's Manual

Advanced function
REMOTE CONTROL
ARC ON TIMER 0 gg. 0:00:00
TIMER WELDER ON 0 gg. 0:13:20
ENERGY SAVING ULTRA
REMOTE CONTROL ANALOGIC RC
A V
95 11.4
ANALOGIC RC
PROGRAM 0004
Fe G3 SI-1 Ø 1.6 CO2
A V
95 11.4
PLC
PROGRAM 0004
Fe G3 SI-1 Ø 1.6 CO2
To exit the ADVANCED CONFIG Menu and go back to the ADVANCED SETUP Menu:
• Push the MENU K
.
EY

ADVANCED MODE

The purpose of this menu is to allow the operator to further refine adjustments to the welding parameters for the machine.
To access the ADVANCED MODE Menu from the ADVANCED SETUP Menu:
• Turn the ENCODER K
NOB
• Push the ENTER/MEM K
EY
ENCODER K
Within the ADVANCED MODE Menu it is possible, by rotating the ENCODER K
quired from the 4 available (according to the welding process selected) and this can be ACTIVATED (this operation does not
require confirmation) by rotating the ENCODER K
Advanced function
CYCLE
CYCLE STANDARD
CRATER STANDARD
DUAL PULSE STANDARD
ARC LENGTH ADJUSTMENT VOLTAGE
TIG LIFT MODE DISABLED
CYCLE ADVANCED
CRATER STANDARD
DUAL PULSE STANDARD
ARC LENGTH ADJUSTMENT VOLTAGE
TIG LIFT MODE DISABLED
By rotating the ENCODER K
can choose to enable and/or disable an analogue output on the welding plant.
• DISABLED - Analogue output disabled, no type of remote control can be connected to
the plant.
• ANALOGIC RC (*) - Analogue output enabled for connection of an ANALOGIC RC
control.
WARNING:
(*) Function enabled by DEFAULT on the welding plant when it comes out of the factory.
The image (to the left) graphically shows how insertion of an ANALOGIC RC remote
control is shown on the VISION S
• PLC - Analogue output enabled for insertion of a live cable if necessary.
WARNING:
The image (to the left) graphically shows how insertion of a a live control (PLC) is
shown on the VISION S
- SX to select the desired icon.
.
MENU K
EY
SX K
EY
- SX
NOB
NOB
If enabled, when operating in STANDARD or ADVANCED mode, this function provides
the operator with a further welding mode (CYCLE) and the special functions associated
with it, when using MIG (pulsed, double pulsed, synergic, or manual) welding processes.
The WELDING MODE SELECTION Menu (MODE) menu will therefore be changed.
This function can only be activated, with the above procedure, on the VISION Display,
whilst it can also be set on the HT4 drag-and-drop once it is activated.
See the special "WELD MODE SELECTION Key" paragraph for correct functioning of the
CYCLE welding mode.
Description
- DX (this operation does not require confirmation) you
NOB
, when the welding machine is working normally.
CREEN
, when the welding machine is working normally.
CREEN
CYCLE DISABLED
CRATER STANDARD
DUAL PULSE STANDARD
ARC LENGTH ADJUSTMENT VOLTAGE
TIG LIFT MODE DISABLED
NOB
- DX.
Description
69
ADVANCED SETUP Menu
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
- SX, to choose the advanced welding mode re-
(continued)