Tig Lift; Special Functions Menu (Set Up Fx) - CEA DIGITECH vision PULSE Series Operator's Manual

TIG LIFT

1 - SPECIAL FUNCTIONS Menu (SET UP Fx)

To access the SPECIAL FUNCTIONS Menu (SET UP Fx) push the SPECIAL FUNCTIONS (F
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
To access the SPECIAL FUNCTIONS Menu (SET UP Fx) push the MENU K
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
ENCODER K - A
NOB
PARAMETER DISPLAY S
CREEN
ENCODER K - V
NOB
SPECIAL FUNCTIONS (F ) K
X EY
SPECIAL FUNCTIONS (F ) LED
X
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access subsequent menus if there are any.
Used to select the various SPECIAL FUNCTIONS (Fx).
Used to access the PRE-SETTING with the changes made to the SPECIAL FUNCTIONS
(Fx).
If held down for 2 seconds it makes it possible to return the value for the SPECIAL
FUNCTION (Fx) selected to the DEFAULT value.
Used to change the selected SPECIAL FUNCTION (Fx) value.
"HT4" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
- A Displays the selected SPECIAL FUNCTION (Fx).
Used to select the various SPECIAL FUNCTIONS (Fx).
- V
Displays the value for the selected SPECIAL FUNCTION (Fx).
Used to change the selected SPECIAL FUNCTION (Fx) value.
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT4 panel and not on the DH panel.
The operator must press the SPECIAL FUNCTIONS (SET UP F
included in the SPECIAL FUNCTIONS Menu (SET UP Fx).
SLOPE UP 2.0 s
DEFAULT
.
EY
45
) K .
X EY
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
) K for it to light up and be
X EY
TIG LIFT
- V
- V
EY