Canceling A Job; Auto Power Down; Powering Off - Stratasys Dimension Elite User Manual

Canceling a Job

You can cancel a job at any time while the part is building.
Cancel a job:
1. Press Pause.
2. Once the printer stops building, press Cancel Build.
The panel displays Are you Sure?
3. Press Yes. The panel displays Build Stopped followed by the part name.
4. The panel prompts you to remove the part and replace the modeling base. See
Modeling Base" on page 28.
panel asks: Part Removed?
5. Press Yes only after removing the part - refer to
CAUTION:
and a service call will be required.

Auto power down

You can set the printer to automatically power down when a build is complete. This option will save
energy usage.
1. While the printer is building, press the Auto Power Down button.
2. Turn the power switch, located on the right side of the printer, to the OFF position.
The printer will display Auto Power Down Mode and the printer will power down as soon as the
build is complete.
Cancelling auto power down:
1. Turn the power switch back to the ON position.

Powering Off

To power-off the printer, move the power switch to the OFF position, see
You can do this at any time without harming the printer. No other steps are necessary. If this is
done while the printer is building a part, the current build will be lost. System cooling fans will
continue to operate for several minutes. This ensures a safe, systematic power down.
Note:
power off the system.
Once the chamber door has been opened and closed, the
If you press before removing the part, the system can be damaged,
Yes
For extended non-use periods, unload the material cartridges and then
"Removing a Completed Part" on
34
"Inserting a
page 35".
Figure 13 on page 15.