Numerical Language" Utility Program (2150); Standard Screen" Utility Program (2800); Eeprom Init" Utility Program (2250) - KaVo EXTRAmatic 9040 Operating Instructions Manual

Operating Instruction EXTRAmatic 9040
|
5 Operation 5.3 Utility programs
▶ Press the back button
This takes you out of the utility program.

5.3.4 "Numerical language" utility program (2150)

▶ Using the the up or down button, select the "Language" utility program and
choose ENTER.
This calls up a list of the different language options.
▶ Using the the up or down button, select the "Language" you require and choose
ENTER.
The required language is now set.
Note
If your language option is not available, you have the option of choosing "numeri‐
cal".
You then have to work with code numbers.

5.3.5 "Standard screen" utility program (2800)

▶ Using the the up or down button, select the "Standard screen" utility program
and choose ENTER.
▶ Using the the up or down button, select the "Combination screen" or "Low pres‐
sure screen" utility program and choose ENTER.
These selection screens appear once the extractor unit has been switched on.
Combination screen: This shows the extraction level required at the different work‐
stations.
Low pressure: This shows the present low pressure.
Factory setting: Combined display
▶ Press the back button
This takes you out of the utility program.

5.3.6 "EEPROM Init" utility program (2250)

▶ Using the the up or down button, select the "EEPROM Init" utility program and
choose ENTER.
▶ Using the up or down button, select Yes or No and choose ENTER.
Choose "no" to retain amendments.
Choose "yes" to reset all settings to the original factory settings.
42/62