KaVo EXTRAmatic 9040 Operating Instructions Manual page 41

Operating Instruction EXTRAmatic 9040
|
5 Operation 5.3 Utility programs
"Control input" identification
This workstation is started up by a control signal (e.g. foot switch or K-Control).
"Continuous" identification
This workstation is in continuous operation mode.
Factory setting: Current identification
Adapt unit
▶ Using the up or down button, select "Adjust unit" and choose ENTER.
▶ Using the up or down button, select "HF" or "no" and choose ENTER.
If you are running an HF unit at this workstation, select HF; otherwise, select "no".
Factory setting: Adjust unit: No
▶ Press the back button.
This takes you out of the utility program.
Examples
Example 1:
3 technical workstations
Settings for workstation 1 (AP1), workstation 2 (AP2) and workstation 3 (AP3)
Extraction level: 24 U
Optimum: No
Current identification
Example 2:
Extraction channel 1: Shape grinder
Extraction channel 2: Sandblaster
39/62