Connecting Via Control Line - KaVo EXTRAmatic 9040 Operating Instructions Manual

Operating Instruction EXTRAmatic 9040
|
4 Start-up 4.2 Connector

4.2.5 Connecting via control line

Whenn the equipment is appropriately set up (such as the K-control unit), a control
signal can be used to control the EXTRAmatic (a connection line is needed from the
equipment to the dust extraction system).
In this case, it is not necessary to plug the power plug of the equipment into the rear
socket.
▶ Press mains switch③ and⑤ into OFF position.
▶ Insert the control line in control sleeve④ of the dust extraction system.
▶ Insert the control line in control sleeve① on the K-Control unit.
▶ Insert the power cable⑥ from the K-Control unit② into the appropriately groun‐
ded socket.
1
2
Kcontrol
30
Nmax
x 1000/min
6
5
4
3
29/62