Recovery And Update - Ricoh SC-10A Operating Instructions Manual

Recovery and Update

Use a USB memory device or SD card (sold separately) to perform a recovery or update of the device's software.
A recovery or update takes about 5 to 10 minutes.
 A recovery or update uses approximately 200 MB of the internal ROM. Free up sufficient memory before performing a
recovery or update.
Do not remove the USB memory device or SD card or turn off the power of the device during the recovery or update.

The device may become no longer able to start.
Turn off the power of the device before performing a recovery or update.

 If a recovery or update is started, the settings of the device and the data stored in internal memory are all deleted.
Do not save multiple update files on the same hierarchical level.

 Do not connect multiple devices at the same time.
 Delete the old update file.
Access the following site and download the update file (sc-10_x_y_z.dat).
1.
http://industry.ricoh.com/en/support/fa_camera_lens/download/soft/
Save the downloaded update file in the layer directly under the USB memory device or
2.
SD card.
Open the USB connector cover or SD card slot cover on the rear of the unit and then
3.
connect the USB device or SD card to which the update file is saved.
Press the power button while holding down the → button and ← button.
4.
 Hold down the → button and ← button until the power LED lamp begins to flash continuously.
 Do not hold down the power button. If the power button is held down for at least 4 seconds, the power of the
device turns off.
 When the recovery or update begins, the power LED lamp begins flashing. Release the → button and ←
button.
 When the recovery or update completes, the power LED lights, a beep sounds, and the device restarts
automatically.
 An SD card or SDHC card can be used with the device.
−
x: Major version
−
y: Minor version 1
−
z: Minor version 2
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
Confirm that the power
LED is flashing
continuously.
90/113