Trademarks; Licenses; Cleaning And Operation/Storage Location - Ricoh SC-10A Operating Instructions Manual

Trademarks

 HDMI is a trademarks or registered trademarks of HDMI Licensing LLC.
 Ethernet is a trademarks or registered trademarks of Fuji Xerox Co., Ltd.
 IEEE is a trademark of The Institute of Electrical and Electronic Engineers, Inc.
 All other product names or names are trademarks or registered trademarks of the respective companies.

Licenses

This product includes software licensed by open source software (OSS) and software from third parties that is subject to
copyright licenses, disclaimers, and notices.
For the exact terms, refer to the DVD supplied with the product.

Cleaning and Operation/Storage Location

Cleaning
 Please note that image quality may deteriorate if fingerprints or dirt gets on the lens.
 When dust or dirt gets on the lens, do not touch the lens directly but instead remove the dust or dirt by using a
commercially available blower to blow it off or using a soft cloth to gently wipe it off.
 In the event that the product malfunctions, contact RICOH Industrial Solutions Inc.
 Never dismantle the product yourself as doing so is dangerous.
 Do not expose this product to volatile substances such as thinner, benzene, and pesticides. Failure to observe this
precaution could result in damage such as deterioration or peeling of paint.
Operation/Storage Location
 Do not install the device in any of the following locations.
 Location where the ambient temperature goes outside of the rated range
 Location subject to sudden changes in temperature (location with condensation)
 Location where the relative humidity goes outside of 30 to 80% RH range
 Location where the device will be directly subject to vibration or impacts
 Location exposed to strong ambient light (laser beams, arc welding light, ultraviolet light, etc.)
 Location subject to direct sunlight or near a heating appliance
 Location subject to a strong magnetic field or intense electric field
 Location where corrosive gas or combustible gas is present
 Location where dust, salt, or iron particles are present
 Location where the atmosphere contains water, oil, or chemical spray or mist
 Avoid using or storing this product in any of the following locations, as they may cause a failure of the product.
 Location with a lot of sand, dirt, or dust
 Location subject to severe vibration
 Location where the product will be in direct contact with chemicals including insect mothballs and other insect
repellent, rubber or vinyl products, etc. for long periods of time.
 Location where a strong magnetic field is generated
 Take care that water does not enter inside this product.
Precautions for Cleaning
 Be sure to turn off the power before cleaning.
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
108/113