Wireless network settings
If [Wireless Network] is selected in [Active] on the [Network] screen, configure the settings for a wireless network
connection.
Click [Wireless Network] of [Network] in the Settings menu of the [Settings] screen
1.
(→P.
34).
The Wireless Network Settings screen appears.
①
②
③
④
⑤
Configure the following settings.
2.
DHCP
①
MAC Address
②
IP Address
③
Status
④
Access Points
⑤
Static IP Address
⑥
Network Mask
⑦
Default Gateway
⑧
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
Set ON or OFF for DHCP.
Click [TEST] to perform a communication check.
When this is set to [ON], clicking [OFF] applies the static IP
address setting.
Displays the MAC address.
Displays the IP address.
Displays the following status information.
Link up: Displayed when communication is possible.
Link down: Displayed when communication is not possible.
Retrieving an IP address from DHCP: Displayed when
getting the IP address from DHCP.
Displays a list of the available access points.
Set the IP address.
This can be set when [DHCP] is set to [OFF].
Set the subnet mask.
This can be set when [DHCP] is set to [OFF].
Set the default gateway.
This can be set when [DHCP] is set to [OFF].
⑥
⑦
⑧
⑨
⑩
⑪
⑫
63/113