Creating Work Items - Ricoh SC-10A Operating Instructions Manual

Creating Inspection Steps
Register an instruction item to a work instruction
number (S/N) input mode).
Multiple inspection steps can be registered to each work instruction. A workflow can be configured by combining multiple
work modes.
Click the Job ID below [Job ID] in the Settings menu of the [Settings] screen
1.
Select a work instruction from [Instruction Steps].
2.
Click [Add] of [Inspection Steps].
3.
 You can also add an inspection step by right-clicking in the list and then selecting [Add to List].
Select a work mode from the pull-down list of [Select Mode].
4.
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
41) and set the work mode (matching mode, check mode, or serial
(→P.
(→P. 34).
45/113