Stopping of Operation
The workflow stops in the following cases.
When the work item is judged to be fail (does not stop when the infinite loop mode is set)
When the [Stop] button is clicked in the main screen
When the power button of the unit is pressed
When the "Start/Stop" signal of the external I/O is input
Screen while stopped
The following operations can be performed while the flow is stopped.
The power LED flashes while the flow is stopped.
①
Change Job ID
①
Back
②
Start
③
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
(→P.
12)
②
④
⑤
③
Changes the job ID.
The job ID can also be changed from [Change Job ID] of the File
menu
(→P.
32).
The job ID cannot be changed when any of the following is set in
user mode.
−
When [External Preset] is enabled
−
When [Job Plan Preset] is enabled
−
When [Job ID] of [Internal Preset] is enabled
Goes to the previous job ID.
Starts the workflow.
(→P.
84)
(→P.
74)
(→P.
(→P.
(→P.
38)
⑥
⑦
57)
58)
(→P.
58)
86/113