Sensor Control - Ricoh SC-10A Operating Instructions Manual

Sensor Control

Set the camera sensor control.
Click [Sensor Control...] in the [System] menu
1.
The [Sensor Control] screen appears.
①
②
③
④
Configure the following settings.
2.
Stop Auto Picture
①
Control
White Balance
②
Exposure
③
Flip Vertical
④
Load
⑤
Save
⑥
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
The auto exposure (AE) and auto white balance (AWB) functions
are enabled by default.
Selecting the check box turns off the AE and AWB functions. The
exposure and white balance values at the time the functions were
turned off are maintained.
Set the white balance from 0 to 384.
 [Red Gain]: Adjusts the red gain.
 [Green Gain]: Adjusts the green gain.
 [Blue Gain]: Adjusts the blue gain.
Set the exposure.
 [Shutter]: Adjusts the shutter. Set from 0 to 672.
 [Gain]: Adjusts the gain. Set from 0 to 64.
The unit is intended for use in suspended manner. If the device is
used by being installed on a tripod, etc. without changing from the
default setting, the image on the screen is vertically inverted.
Selecting the check box in this case inverts the top and bottom of
the image to display the image in the correct orientation.
Loads the saved white balance and exposure setting states.
Saves the manually set white balance and exposure setting
states.
(→P. 33).
⑤ ⑥
⑦
76/113