External I/O Settings - Ricoh SC-10A Operating Instructions Manual

External I/O Settings

Assign functions to the external connector pins (→P. 33).
Click [External I/O Settings...] in the [System] menu
1.
The [External I/O Settings] screen appears.
 The [External I/O Settings] screen can also be displayed by clicking [External I/O Settings...] in the [Internal
Preset] screen
 For the input and output timing, refer to the external I/O timing chart
Configure the following settings.
2.
Input
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
(→P. 57).
Set the input functions of the external connector pins.
 [IN0]: Sets the input function of pin No. 8. [Unused], [EXTIN],
[Start/Stop] can be set.
 [IN1]: Sets the input function of pin No. 9. [Unused], [EXTIN],
[PRESET 0], and [CHG WORK ID] can be set.
 [IN2]: Sets the input function of pin No. 10. [Unused], [EXTIN],
[PRESET 1], and [ENTER] can be set.
 [Polarity (edge)]: Sets the signal polarity for the input trigger. "↑"
indicates a high signal, and "↓" indicates a low signal.
 [Monitor]: Sets the polarity for the input signal.
 [Job ID change by external input]: Enables the external preset.
Operation is the same as when [Job ID change by external input] of
[External Preset]
(→P.
(→P. 57).
33).
(→P. 103).
73/113