Power-On And Initial Settings - Ricoh SC-10A Operating Instructions Manual

Power-on and Initial Settings

 Connect a monitor to the device
device.
The device refers to the monitor information to determine the output resolution at startup. If the monitor information
cannot be acquired, the screen will not be displayed correctly.
 SXGA (1280x1024) and 1080p (1920x1080) are supported for the screen resolution.
Output is at 1080p if the optimal resolution of the monitor is 1080p, and at SXGA if the optimal resolution is other than
that.
Press the power button on the top of the unit.
1.
The [Initial Settings] screen appears after the first startup or executing a reset from [Initial Settings...]
the [Settings] menu.
Configure the following settings on the [Initial Settings] screen.
2.
Password
①
Area
②
Location
③
Language
④
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
(→P. 24) and turn on the power of the monitor before turning on the power of the
⑤
⑥
⑦
Set the administrator password.
 The initial password is "root." Change the password from the
initial password for security reasons.
 Set a password from 1 to 20 characters long.
 Alphanumeric characters (a-z, A-Z, and 0-9), underbars (_),
and periods (.) can be entered for the password.
 The password is case sensitive.
Select a work mode from the pull-down list.
Select a work mode from the pull-down list.
 If the corresponding location is not in the list, select the one
that is the closest.
Select the display language from the pull-down list.
(→P. 33)
①
②
③
④
of
27/113