Sound / Led Settings - Ricoh SC-10A Operating Instructions Manual

Sound / LED Settings

Set the beep volume and the lighting mode of the LEDs.
Click [Sound/LED] in the Settings menu of the [Settings] screen
1.
The [Sound / LED Settings] screen appears.
Configure the following settings.
2.
Sound/Volume
①
Sound/Job Progress
②
Alert
LED/Mode
③
Click [Save].
3.
The settings are saved.
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
①
②
Set the beep volume.
 [None]: A beep does not sound.
 [Low]: Sets the volume to low.
 [High]: Sets the volume to high.
When you select [Low] or [High], the beep sounds so that you can
check the volume.
Set the alert (beep sound) for when a time is specified in the
[Time] setting when creating a work item
 [None]: A beep does not sound.
 [Delayed]: Sounds a beep during the time limit.
[Constant]: Sounds a beep during matching fail detection.

Set the lighting mode of the OK and fail LEDs for inspection step
judgment.
 [One Shot]: Lights for a set time when inspection step
judgment.
 [Keep]: Keeps the OK/fail lighting state until the next
inspection step completes.
(→P. 34).
③
(→P.
46).
69/113