Check Mode Parameters - Ricoh SC-10A Operating Instructions Manual

Check mode parameters

If [Check] is selected for the work mode setting when registering the inspection step, set the check method (trigger) when
using the external I/O, and enable or disable the output functions assigned to the external connector pins.
Set Timeout, OK, and fail operation in [Judgment Conditions].
1.
Timeout
OK
fail
RICOH SC-10 SERIES
Operating Instructions Rev. 4.00
Sets the judgment condition for when timeout.
 [fail]: Judgment becomes fail.
 [OK]: Judgment becomes OK.
Configure the judgment condition (OK) settings.
 [Button]: Performs the judgment manually.
 [EXTIN0]/[EXTIN1]/[EXTIN2]: Performs the judgment using the signal
of the input pin (→P.
 [Disable]: Disables the OK button.
Configure the judgment condition (fail) settings.
 [Button]: Performs the judgment manually.
 [Disable]: Disables the fail button.
73) of the external connector as the trigger.
54/113