Table of Contents
Advertisement
Table 1-10. Addressing Modes
No.
Mode
(1)
Register direct
(2)
Register indirect
(3)
Register indirect with 16-bit displacement
(4)
Register indirect with post-increment
Register indirect with pre-decrement
(5)
Absolute address (8 or 16 bits)
(6)
Immediate (3-, 8-, or 16-bit data)
(7)
PC-relative (8-bit displacement)
(8)
Memory indirect
(1) Register Direct--Rn: The register field of the instruction specifies an 8- or 16-bit general
register containing the operand. In most cases the general register is accessed as an 8-bit
register. Only the MOV.W, ADD.W, SUB.W, CMP.W, ADDS, SUBS, MULXU (8 bits × 8
bits), and DIVXU (16 bits ÷ 8 bits) instructions have 16-bit operands.
(2) Register indirect--@Rn: The register field of the instruction specifies a 16-bit general
register containing the address of the operand.
(3) Register Indirect with Displacement--@(d:16, Rn): This mode, which is used only in
MOV instructions, is similar to register indirect but the instruction has a second word (bytes
3 and 4) which is added to the contents of the specified general register to obtain the operand
address. For the MOV.W instruction, the resulting address must be even.
(4) Register Indirect with Post-Increment or Pre-Decrement--@Rn+ or @-Rn:
Register indirect with post-increment @Rn+
The @Rn+ mode is used with MOV instructions that load registers from memory. It is
similar to the register indirect mode, but the 16-bit general register specified in the
register field of the instruction is incremented after the operand is accessed. The size of
the increment is 1 or 2 depending on the size of the operand: 1 for a byte operand; 2 for a
word operand. For a word operand, the original contents of the 16-bit general register
must be even.
Register indirect with pre-decrement @-Rn
The @-Rn mode is used with MOV instructions that store register contents to memory. It
is similar to the register indirect mode, but the 16-bit general register specified in the
register field of the instruction is incremented before the operand is accessed. The size of
the decrement is 1 or 2 depending on the size of the operand: 1 for a byte operand; 2 for a
word operand. For a word operand, the original contents of the 16-bit general register
must be even.
26
Notation
Rn
@Rn
@(d:16, Rn)
@Rn+
@-Rn
@aa:8, @aa:16
#xx:3, #xx:8, #xx:16
@(d:8, PC)
@@aa:8
Advertisement
Table of Contents
