Hitachi H8/300L Series Programming Manual page 143

Table 2-2. List of Instructions (7)
Mnemonic
XORC #xx:8,CCR B
NOP --
EEPMOV --
Notes: The number of execution states indicated here assumed that the operation code and
operand data are in on-chip memory. For other cases, refer to section 2.5, Number of
Execution States.
(1) Set to 1 when there is a carry or borrow at bit 11; otherwise cleared to 0.
(2) When the result is 0, the previous value remains unchanged; otherwise cleared to 0.
(3) Set to 1 when there is a carry in the adjusted result; otherwise the previous value
remains unchanged.
(4) The number of execution states is 4n + 9, with n being the value set in R4L.
(5) Set to 1 when the divisor is negative; otherwise cleared to 0.
(6) Set to 1 when the divisor is 0; otherwise cleared to 0.
Addressing Mode and
Instruction Length (Bytes)
Operation
CCR⊕#xx:8 → CCR 2
PC ← PC+2
if R4L≠0 Repeat
@R5 → @ R6 R5+1
→ R5 R6+1 → R6
R4L-1 → R4L Until
R4L=0 else next;
Condition Code
I H N Z V0 C
∆ ∆ ∆ ∆ ∆ ∆
2 - - - - - -
4 - - - - - - (4)
137
2
2