Recording The Transceiver Communication Audio; M The Recording Settings - Icom VE-PG4 Installation Manual

2
SETTING UP THE TRANSCEIVERS

Recording the transceiver communication audio

You can record the communication audio between the transceivers to an external storage device that is
connected to the USB port of the RoIP Gateway.
You can enter up to 4 recording boxes. To each recording box, you can set conditions to be recorded, such as
the type of call or the target (Unit ID or Group ID).
L You cannot record the calls as follows:
• Between IP phones
• Between IP phone and IP transceivers
• Direct communication between digital transceivers
• Communication through a bridge connection
L The recording stops after detecting a mute for the set period of time. (Default: 5 seconds)
L A data transmission while recording is recorded as a mute.
Expert Settings > Call Recording
■ The Recording settings
(Example: recording All Calls to the Box 1)
1
Open the Call Recording screen.
(Expert Settings > Call Recording)
2
In [Recorder Setting], select Mode (Example: Recording) and Call Type (Example: All), and then click
<Apply>.
L When you select "Monitor, " in the Mode setting, the RoIP Gateway outputs the audio to the specified port.
Refer to the Operating guide for details.
3
Confirm the settings in [List of Recording Box Entries].
2-22
q Select
w Select
e Click
Confirm