Icom VE-PG4 Installation Manual page 3

INTRODUCTION
Features
• The VE-PG4 RoIP Gateway enables you to communicate between transceivers, wireless LAN transceivers
or IP telephones, that are connected to the RoIP Gateway, through IP networks.
Controls IP transceivers and wireless LAN transceivers through a 4G/3G line.
L Panasonic KX series IP telephones are usable, as of April, 2019.
L The 3G/4G line is required to connect to the IP transceiver controller.
L A total of up to 50 wireless LAN transceivers and IP100FSs remote communicator, and up to 25 IP telephones can
be registered and used in the VE-PG4 system.
• Connects to speakers in the system,
• Enables emergency calls to linked transceivers and speakers, and monitors unusual operation of the linked
transceivers.
• A USB flash drive can be connected to the USB port for such as recording the audio communication between
transceivers and telephones, updating the firmware and backing up or restoring the settings.
• Supports SNMP for network management.
• IP filtering function that restricts access from unknown network addresses.
• Automatic switching between 10BASE-T, 100BASE-TX, and 1000BASE-T.
L This document is described based on the VE-PG4 firmware version 1.03.
Supported Icom radio products
The following Icom transceivers can be connected to a VE-PG4.
L Some models may not be available in some countries. Ask your dealer for details.
Category Model
Marine IC-M604A/
IC-M605 series
Land IC-F5060 series/
IC-F6060 series
Aviation
IC-A120 series
Repeater IC-FR5000 series/
IC-FR6000 series
*The optional UC-FR5000 must be installed.
Description
Mode
in this manual
IC-M604
Analog
IC-M605
IC-F5060/F6060 Analog
IC-A120 Analog
IC-FR5000/
Analog
FR6000
NXDN Type-D/
dPMR Mode 2
ii
(As of April, 2019)
Connected to Cable (optional)
[EXT] (EXT I/O) OPC-2273
[EXT] (EXT I/O) OPC-2275
[EXT] (EXT I/O) OPC-2275
[EXT] (EXT I/O) OPC-2390
[LAN]* LAN (User supplied)