Icom VE-PG4 Installation Manual page 11

1
BEFORE USING THE VE-PG4
Panel description
■ Front panel
<USB1> BUTTON ����
15
<UPDATE> BUTTON ���
16
<MODE> BUTTON ����
17
[MIC] PORT �������
18
18 17 16 15
When removing the USB flash drive, hold down this button until
[USB1] (11) turns OFF.
When [MSG] lights green, a firmware update is ready. Hold down this
button until [MSG] blinks green to update the firmware.
L When you do not use the 4G or 3G line, an internet connection is necessary
for the firmware update through the network.
L Use a pin to push the button.
Push to initialize the settings. See Section 5 for details.
L Use a pin to push the button.
Connect to the optional speaker-microphone.
Insert the speaker-microphone connector until it clicks.
L Turn OFF the VE-PG4 before connecting or disconnecting the speaker-
microphone.
L Never connect a LAN cable to the [MIC] port.
L The [MIC] and [EXT1] ports cannot be used at the same time.
While a speaker-microphone is connected, audio input to or output from the
[EXT1] port on the rear panel is muted.
1 2 3 4 5 6
14 13 12 11 10 9
1-5
7
8