Icom VE-PG4 Installation Manual page 117

6
FOR YOUR INFORMATION
Using the Virtual serial port
■ Installing the Virtual serial port
7
Click "Port setting," enter the IP address of the VE-PG4 and the TCP port number, and then click <OK>.
8
Confirm the port settings, and then click <Close>.
These settings are typically set by
the applications that uses the serial
communication.
The values in this setting are not
valid in that case.
Uncheck when you set the Data Mode
(p. 6-15) to "Auto."
6-17
q Select
w Enter
q Confi rm
w Click