Icom VE-PG4 Installation Manual page 13

1
BEFORE USING THE VE-PG4
Panel description
■ Rear panel
[USB2]/[USB3] PORTS
6
(USB3.0) ��������
<USB2/3> BUTTON ���
7
[EXT1] ~ [EXT4] PORTS �
8
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4
8
Connect a USB flash drive (user supplied) to restore the settings or to
update the firmware.
L You can save the recorded audio on a data storage device through the USB
port. Only one storage device can be connected to the USB port at a time.
L Be sure to back up the data on the USB flash drive before connecting it to
the VE-PG4.
L A USB flash drive such as one with biometric authentication, or one with
password protection, is not supported.
L Some USB devices may not be usable with the VE-PG4.
L The VE-PG4 accepts up to two CT-24s for optional AMBE+2 vocoder.
Before removing the USB flash drive, hold down this button until the
indicator below the button turns OFF.
Connect external devices or transceivers.
L Be sure that both the VE-PG4 and the connected devices or transceivers are
turned OFF when connecting or disconnecting the cables.
L The default settings for the [EXT] ports are:
[EXT1] / [EXT2]: To connect to a transceiver
[EXT3] / [EXT4]: To connect to an external I/O port
See the Section 6 for details on the [EXT] ports.
1 2 3
7 6
1-7
1
5 4