Icom VE-PG4 Installation Manual page 97

5
MAINTENANCE
Restoring the settings from the USB flash drive
Management > Settings Backup/Restore
7
Unmount and remove the USB flash drive from the PC.
8
Locate the VE-PG4 that you want to load settings from the USB flash drive.
9
Insert the USB flash drive to the VE-PG4. (Example: the [USB1] port)
• The [USB1] indicator lights green when the USB flash drive is successfully
mounted.
10
Push the <USB1> button.
• The VE-PG4 starts reading the settings from the drive.
• After the settings are loaded successfully, the VE-PG4 restarts.
11
Confirm the [PWR] indicator lights green, and hold down
<USB1> button until the [USB1] indicator turns OFF.
Confirm the [USB1] indicator turns OFF, and then
remove the USB flash drive from the VE-PG4.
L The automatically saved VE-PG4 settings data is located
as the bakdata.sav on the USB flash drive,
CAUTION:
• DO NOT remove the USB flash drive or turn OFF the VE-PG4 until the setting file is completely restored.
Otherwise the settings data or the VE-PG4 may be damaged.
• DO NOT access the VE-PG4 setting screen until it is completely rebooted.
• Before removing the USB flash drive, confirm the [USB] indicator is not lit.
TIP: When the USB flash drive is enabled
(Management > Management Tools > USB)
If the VE-PG4 reboots while a USB flash drive is attached, the VE-PG4 starts reading from the USB flash
drive.
Hold down
q
<USB1>
5-14
Push <USB1>
Confirm [USB1]
w
has turned OFF
Remove the
e
USB flash drive
[USB1]
port