Icom VE-PG4 Installation Manual page 41

2
SETTING UP THE TRANSCEIVERS
NXDN Conventional mode operation
■ Connecting the transceiver to the RoIP Gateway
1
Set the transceiver channel, volume level, TX output power, and other necessary settings, before
connecting to the RoIP Gateway.
NOTE: Turn OFF both the RoIP Gateway and the transceiver before connecting the cable.
2
Connect the RoIP Gateway and the transceiver, using the appropriate optional cable.
VE-PG4 (Rear view)
To [EXT1] (Lower slots)
A1~A4 A1~A4 B1~B4 B1~B4
A A B C
L The [EXT1] and [EXT2] ports (lower slots) accept transceivers, by default.
3
Turn ON the transceiver and the RoIP Gateway.
NOTE:
• Turn OFF both the radio and the RoIP Gateway when connecting or disconnecting the transceiver.
• Keep the radio away from a PC, AC adapter and other electronic equipment. The noise emitted from those
equipment may interfere with the radio.
• When operating the radio, do not transmit near the IP telephone.
NOTE: 4 Internal AMBE+2 vocoders can be assigned to the digital transceivers. If you need an additional
AMBE+2 vocoder, an optional CT-24
Cushion
Cushion sheet
(Supplied with the CT-24)
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4
Be sure to insert the
C1~C4 C1~C4
A B C
connectors top side up
OPC-2275
digital voice converter
Status Indicator
Lights green: Power ON
Blinks orange: Communicating
leg
CT-24
To the external speaker jack
A
1 2 3 4
Top Bottom
is required.
USB cable
(supplied with the CT-24)
2-16
Icom transceiver
(IC-F5060/IC-F6060)
To the microphone connector
Before connecting the cable,
turn OFF the VE-PG4.
(Rear view)
(Front view)