Icom VE-PG4 Installation Manual page 29

2
SETTING UP THE TRANSCEIVERS
Multicast mode operation
■ Registering a transceiver to the RoIP Gateway
1
Open the Bridge Connection screen.
(Bridge Connection Settings > Bridge Connection)
2
In [Bridge Connection], confirm the connection Source (Example: EXT1), the Bridge Connection
Destination (Custom Bridge Connection), and the IP address of the destination (239.255.255.1), then
click <Apply>.
• The confi rmation dialogs are displayed. Click <OK> twice to apply them.
L When the bridge connection is set, the Connection Port setting is deleted from the "Destination Settings"
(Destination settings > Destination Settings)
3
In [AMBE+2 Vocoder Assignment], select the Voice Protocol and AMBE+2 Vocoder Assignment, and
then click <Apply>.
L By default, all of the 4 Internal AMBE+2 vocoders are assigned to the digital transceivers. Disable one of the
internal AMBE+2 vocoders to assign it to the EXT1 port.
L If you need an additional AMBE+2 vocoder, an optional CT-24
digital voice converter
2-4
q Confirm
w Enter
e Click
q Select
w Click
is required.
(☞ Continued on the next page)