Ospf Packet-Process Prioritized-Treatment; Ospf Timer Dead - H3C S5820X Series Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5820X Series:
- Command reference manual (488 pages) ,
- Configuration manual (252 pages) ,
- High availability configuration manual (233 pages)
Table of Contents
Advertisement
Examples
# Configure an interface's OSPF network type as NBMA.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf network-type nbma
ospf packet-process prioritized-treatment
Syntax
ospf packet-process prioritized-treatment
undo ospf packet-process prioritized-treatment
View
System view
Default level
2: System level
Parameters
None
Description
Use the ospf packet-process prioritized-treatment command to enable OSPF to give priority to receiving
and processing Hello packets.
Use the undo ospf packet-process prioritized-treatment command to restore the default.
By default, this function is not enabled.
Examples
# Enable OSPF to give priority to receiving and processing Hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment
ospf timer dead
Syntax
ospf timer dead seconds
undo ospf timer dead
View
Interface view
Default level
2: System level
Parameters
seconds: Dead interval in seconds, in the range 1 to 2147483647.
Description
Use the ospf timer dead command to set the dead interval.
115
Advertisement
Table of Contents
