Preference; Reset Rip Process - H3C S5820X Series Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5820X Series:
- Command reference manual (488 pages) ,
- Configuration manual (252 pages) ,
- High availability configuration manual (233 pages)
Table of Contents
Advertisement
preference
Syntax
preference [ route-policy route-policy-name ] value
undo preference [ route-policy ]
View
RIP view
Default level
2: System level
Parameters
route-policy-name: Routing policy name with 1 to 63 characters.
value: Preference for RIP routes, in the range of 1 to 255. The smaller the value, the higher the preference.
Description
Use the preference command to specify the preference for RIP routes.
Use the undo preference command to restore the default.
By default, the preference of RIP routes is 100.
You can specify a routing policy by using the keyword route-policy to set a preference for the matching
RIP routes.
•
The preference set by the routing policy applies to all matching RIP routes. The preference of other
routes is set by the preference command.
If no preference is set by the routing policy, the preference of all RIP routes is set by the preference
•
command.
Examples
# Set the RIP route preference to 120.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120
reset rip process
Syntax
reset rip process-id process
View
User view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the reset rip process command to reset the specified RIP process.
47
Advertisement
Table of Contents
