Rip Metricout - H3C S5820X Series Command Reference Manual

[Sysname-route-policy] if-match ip-prefix 123
[Sysname-route-policy] apply cost 6
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricin route-policy abc 2

rip metricout

Syntax
rip metricout [ route-policy route-policy-name ] value
undo rip metricout
View
Interface view
Parameters
route-policy route-policy-name: Specifies the name of a routing policy used to add an additional metric
for the routes matching it. The name is a string of 1 to 63 characters.
value: Additional metric of sent routes, in the range of 1 to 16.
Description
Use the rip metricout command to add a metric to sent routes.
Use the undo rip metricout command to restore the default.
By default, the additional metric for sent routes is 1.
With the command configured on an interface, the metric of RIP routes sent on the interface will be
increased.
If a routing policy is referenced with the route-policy keyword, the following operations can be
performed:
Routes matching the policy is added with the metric specified in the apply cost command
•
configured in the policy. Routes not matching it is added with the metric specified in the rip
metricout command. The rip metricout command does not support the + or – keyword—used to
add or reduce a metric—specified in the apply cost command. For more information about the
apply cost command, see the chapter "Routing policy configuration commands."
If the apply cost command is not configured in the policy, all the advertised routes is added with the
•
metric specified in the rip metricout command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 for the outgoing route 1.0.0.0/8 and to add a metric
of 2 for other outgoing routes.
<Sysname> system-view
[Sysname] ip ip-prefix 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy] if-match ip-prefix 123
[Sysname-route-policy] apply cost 6
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricout route-policy abc 2
53