Ospfv3 Timer Hello; Ospfv3 Timer Retransmit - H3C S5820X Series Command Reference Manual

OSPFv3 neighbor dead time: if an interface receives no hello packet from a neighbor after dead time
elapses, the interface will consider the neighbor dead.
The dead seconds value is at least four times the Hello seconds value and must be identical on interfaces
attached to the same network segment.
Related commands: ospfv3 timer hello.
Examples
# Configure the OSPFv3 neighbor dead time as 80 seconds for the interface in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer dead 80 instance 1

ospfv3 timer hello

Syntax
ospfv3 timer hello seconds [ instance instance-id ]
undo ospfv3 timer hello [ seconds ] [ instance instance-id ]
View
Interface view
Default level
2: System level
Parameters
seconds: Interval between hello packets, ranging from 1 to 65535.
instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.
Description
Use the ospfv3 timer hello command to configure the hello interval for an interface that belongs to an
instance.
Use the undo ospfv3 timer hello command to restore the default .
By default, the hello interval is 10 seconds for P2P and Broadcast interfaces, and is not supported on the
P2MP or NBMA interfaces.
Related commands: ospfv3 timer dead.
Examples
# Configure the hello interval as 20 seconds for an interface in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer hello 20 instance 1

ospfv3 timer retransmit

Syntax
ospfv3 timer retransmit interval [ instance instance-id ]
undo ospfv3 timer retransmit [ interval ] [ instance instance-id ]
334