Enable Link-Local-Signaling; Enable Log - H3C S5820X Series Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5820X Series:
- Command reference manual (488 pages) ,
- Configuration manual (252 pages) ,
- High availability configuration manual (233 pages)
Table of Contents
Advertisement
Cost: 1562
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 27 Output description
Field
Virtual-link Neighbor-ID
Neighbor-State
Interface
Cost
State
Type
Transit Area
Timers
enable link-local-signaling
Syntax
enable link-local-signaling
undo enable link-local-signaling
View
OSPF view
Default level
2: System level
Parameters
None
Description
Use the enable link-local-signaling command to enable the OSPF link-local signaling (LLC) capability.
Use the undo enable link-local-signaling command to disable the OSPF link-local signaling capability.
By default, this capability is disabled.
Examples
# Enable link-local signaling for OSPF process 1.
<Sysname> system-view
[Sysname] ospf 1
[Sysname-ospf-1] enable link-local-signaling
enable log
Syntax
enable log [ config | error | state ]
State: P-2-P
Type: Virtual
Description
ID of the neighbor on the virtual link
Neighbor State: Down, Init, 2-Way, ExStart, Exchange, Loading, Full.
IP address and name of the local interface on the virtual link
Interface route cost
Interface state
Type: virtual link
Transit area ID
Values of timers: hello, dead, poll (NBMA), retransmit, and interface
transmission delay
92
Advertisement
Table of Contents
