Dampening (Bgp/Bgp-Vpn Instance View) - H3C S5820X Series Command Reference Manual

[Sysname] bgp 100
[Sysname-bgp] confederation id 10
[Sysname-bgp] confederation peer-as 2000 2001

dampening (BGP/BGP-VPN instance view)

Syntax
dampening [ half-life-reachable half-life-unreachable reuse suppress ceiling | route-policy
route-policy-name ] *
undo dampening
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
half-life-reachable: Specifies a half-life for active routes from 1 to 45 minutes. By default, the value is 15
minutes.
half-life-unreachable: Specifies a half-life for suppressed routes from 1 to 45 minutes. By default, the
value is 15 minutes.
reuse: Specifies a reuse threshold value for suppressed routes from 1 to 20000. A suppressed route
whose penalty value decreases under the value is reused. By default, the reuse value is 750.
suppress: Specifies a suppression threshold from 1 to 20000. The route with a penalty value higher than
the threshold is suppressed. The default value is 2000.
ceiling: Specifies a ceiling penalty value from 1001 to 20000. The value must be bigger than the
suppress value. By default, the value is 16000.
route-policy-name: Routing policy name, a string of 1 to 63 characters.
half-life-reachable, half-life-unreachable, reuse, suppress and ceiling are mutually dependent. Once any
one is configured, all the others should also be specified.
Description
Use the dampening command to enable BGP route dampening, configure dampening parameters, or
both.
Use the undo dampening command to disable route dampening.
By default, no route dampening is configured.
The command dampens only eBGP routes rather than iBGP routes.
Related commands: reset bgp dampening, reset bgp flap-info, display bgp routing-table dampened,
display bgp routing-table dampening parameter and display bgp routing-table flap-info.
Examples
# In BGP view, configure BGP route dampening.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] dampening 15 15 1000 2000 10000
202