Default-Route - H3C S5820X Series Command Reference Manual

Parameters
value: Default metric of redistributed routes, in the range of 0 to 16.
Description
Use the default cost command to configure the default metric for redistributed routes.
Use the undo default cost command to restore the default.
By default, the default metric of redistributed routes is 0.
When you use the import-route command to redistribute routes from other protocols without specifying
a metric, the metric specified by the default cost command applies.
Related command: import-route.
Examples
# Configure the default metric for redistributed routes as 3.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default cost 3

default-route

Syntax
default-route { only | originate } [ cost cost ]
undo default-route
View
RIP view
Default level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises both a default route and other routes.
cost: Cost of the default route, in the range of 1 to 15. The default is 1.
Description
Use the default-route command to configure all the interfaces under the RIP process to advertise a default
route with the specified metric to RIP neighbors.
Use the undo default-route command to disable all the interfaces under the RIP process from sending a
default route.
By default, no default route is sent to RIP neighbors.
The RIP router with this feature configured will not receive any default routes from RIP neighbors.
Related commands: rip default-route.
Examples
# Configure all the interfaces under RIP process 100 to send only a default route with a metric of 2 to RIP
neighbors.
<Sysname> system-view
32