Optional Functions - Fermax LYNX VIVO User& Installer's Manual

LYNX Monitor
3.1.9.3 General Settings. Installer Settings LIFT CONTROL SETTINGS
The Lift Control Settings function allows you to program the relays that are activated when the
lift control icon is pressed. Up to 3 relays can be activated when this icon is pressed (depending
on the installation / confi guration set up by the installer). The relay must be in the same block
as the monitor.
For more information on the programming procedure,
Unit (PMU).
The fi elds required to confi gure the relay are: Group, Module and Relay.
- Group: The group is associated with the lift number.
- Module: Relay module (slave number).
- Relay: Relay number, (physical output of the module relay).
Notes:
The relay modules are installed in groups (groups of relays), each group has:
• Master IP relay module: 4 relays.
• 0 or more RS-485 slave modules: up to 32 modules, each with 10 relays.
• Power Supply (at least 1, the number depends on the number of slave modules).
- Each group of relays controls a lift, and each group of relays has a unique IP address.
- Each IP module can manage 4 relays. Each slave module can manage 10 relays. In this way, a group
can manage between 4 and 324 relays (i.e more than 320 fl oors).
When the lift control icon is pressed on the start menu, the lift is sent to the fl oor where the
user lives (for a predetermined period of time). The monitor displays the action undertaken on
the screen.
3.1.9.4 General Settings. Installer Settings OPTIONAL FUNCTIONS
The Optional functions feature allows the installer to activate icons that are not available by
default. Using this function, the installer can enable or disable the options (icons) available on
the monitor.
see manual 970021 Property Management
Page 23