Installer Settings; Monitor Settings - Fermax LYNX VIVO User& Installer's Manual

LYNX Monitor
3.1.9 General Settings. INSTALLER SETTINGS
Press Installer Settings, enter the installer PIN code (which is 4444 by default), press OK and
access the screen containing various icons allowing you to make adjustments.
Note:
- The installation settings function is protected by a PIN so that it can only be manipulated by qualifi ed
personnel.
3.1.9.1 General Settings. Installer Settings MONITOR SETTINGS
The monitor's IP address can be confi gured by choosing between different modes, which
are as follows:
vivo
- Standard Lynx mode (default selection).
- DHCP mode.
- Static IP mode.
smile
Note:
- All devices on the same installation must be confi gured following the same mode, either all set to Lynx
Mode, or all set to static DHCP / IP mode.
Open to select other modes
Page 21