Table of Contents
Advertisement
SENSOR: Choose the type of sensor used in this area, between SMOKE, GAS,
MOTION, DOOR, WINDOW, PANIC, TAMPER and SOS.
This is the information that will appear on the monitor screen after the corresponding
alarm is triggered and sent to the GU and MEET Management Software.
INPUT: Choose between 3C, NO, NC or BELL.
• 3C: If you have used the anti-tamper monitoring resistor in the sensor installation.
• NO: If a Normally Open type sensor has been used.
• NC: If a Normally Closed type sensor has been used.
• BELL: If this area has been used to install a doorbell button.
DELAY: If a DELAY type sensor has been selected, select the required delay time from
the options offered (0, 5, 15, 20, 25, 40 or 60 seconds).
MODES: Select the MODES in which you want each of the zones to be active,
according to the type of sensor and the installation carried out.
LOOP DETECT: Select this box if you want the system to monitor the status of the sensors
every time you select NIGHT or OUT from the HOME mode.
In the event that a sensor in the NIGHT or OUT zones is activated, the user will be warned
by a message on the screen. It will not be possible to change the mode until the incident has
been corrected.
This makes it possible, for example, to avoid false alarms or security failures, if a door
or window is left open at the time that SLEEP or OUT mode is selected.
4.4. ENABLE/DISABLE FUNCTIONS
Touch the icon
functions are to be blocked.
12
NEO MEET INSTALLER MANUAL
to select which functions are to be available to the user and which
Advertisement
Table of Contents
