Timer; Screen Cleaning - Fermax LYNX VIVO User& Installer's Manual

LYNX Monitor
Notes:
- Due to the message capacity limit, if the number of saved messages reaches the maximum and a new message
arrives, the oldest message will be deleted in order to allow the new message to be recorded.
- If there is more than one monitor in the house, actions taken on one of them will affect the others (e.g. Deleting
all messages, marking them as read, etc, ...), i.e. the message list is synchronised across all monitors in the
same property.
- The user will have access to the messages menu through the receive messages icon, as explained in the
previous pages, if PIN Required is not selected in
3.2.16 Default functions + Optional functions enabled. TIMER
With the timer function, the user can set a countdown alarm that will issue a warning when the
time reaches 0.
When the timer icon is selected, a screen with a counter is displayed allowing you to select hours,
minutes and seconds, the default time is: 00:00:00. By sliding a fi nger down or up on each number,
you can select the desired value. The timer can be set, like a countdown alarm, for a maximum
time of 99 hours, 59 minutes, 59 seconds down to a minimum of 1 second.
Pressing confi rm starts the countdown and returns to the start menu (the remaining time will be
displayed in the lower left of the screen).
When the counter reaches 00:00:00, the selected sound will be played. It is possible to cancel
the countdown alarm by pressing the timer icon and selecting the cancel option.
Note:
- The timer alarm tone can be selected. This may be done by selecting General Settings and accessing
the screen where the
3.2.17 Default functions + Optional functions enabled. SCREEN CLEANING
The screen cleaning feature will disable the touch screen and capacitive buttons for 30 seconds.
During this time no action is recognised from the touch interface, giving the user time to clean
the screen.
A countdown indicating the remaining time will be displayed on the screen.
3.1.6 (User) Privacy Settings.
3.1.1 Call Settings option is located.
Reading messages.
Page 45