Doorbell Settings - Fermax LYNX VIVO User& Installer's Manual

LYNX Monitor
Group: Name of the relay group.
· This is the last digit of the IP address selected in the corresponding main IP relay module,
Ref.1615.
Module: module number
· Indicate 255 to select the main module.
· Indicate 1 -32 to select a secondary module.
Relay: relay number on said module
· Indicate 0-3 for the main module.
· Indicate 0-9 for the secondary module.
The changes will take effect once the user saves them by clicking the OK button.
NOTE: The monitor can only access those relay modules belonging to its own "block" number.
3.1.9.11 General Settings. Installer Settings DOORBELL SETTINGS
This function allows you to confi gure an IP camera to be displayed on the monitor every time the
doorbell is pressed (the doorbell of the house).
Note:
- Once this function is enabled, whenever the monitor receives a ringtone event, it will display a video
transmission from the selected IP camera. The monitor's communication screen shows the same icons
as the IP camera auto switch-on, except for the duration of the connection. This communication will
last 30 seconds only. Communication between the camera and the monitor will end after 30 seconds.
In the Door Bell Settings screen you can enable the "Door Bell Camera IP" option by selecting
the check box to connect to the desired IP camera. You must select a specifi c camera for the
doorbell, only the cameras added from the IP camera confi guration are shown.
Page 29