Vivo/Vivo+ Monitor; A) Connectors - Fermax LYNX VIVO User& Installer's Manual

LYNX Monitor

7.2 VIVO/VIVO+ MONITOR.

a) Connectors

Monitor connections.
- 30 pins to connect to monitor connector.
- Mini USB (internal) for the fi rmware (at startup).
- SD card slot.
Monitor connector.
Connections:
RJ-45 10/100 Base -T Ethernet, powered by mains socket RJ-45.
NG, P: To connect a secondary external SOS panic button (dry contact).
NG, B: To connect a button for the doorbell.
Note:
- When the doorbell is pressed, the melody selected for this call will be played. The monitor screen will not activate.
If the doorbell is pressed during the conversation, the melody is not heard, but a message is displayed on the
screen.
D1, D2: RS-485 serial port to communicate with other future systems.
A1, A2: RS-485 serial port to communicate with the alarm system.
+, - : 12 Vdc power supply, (if Class 0 PoE switch is not used).
12 Vdc consumption:
VIVO Monitor (7" TFT screen)
* Standby: 310mA.
* Maximum: 700mA.
VIVO PLUS Monitor (10" TFT screen)
* Standby: 310mA.
* Maximum: 850mA.
- 1, 2, 3, 4, 6, V, M, Ct: To connect an analogue panel (4 + n).
Notes:
- Calls can also be received from an analogue video panel in the house (4 + N single line). In this case, the
analogue panel is connected to the pins reserved for this connection. The process of receiving the call is the
same as normal, with the following limitations:
- If there is more than one monitor in the house, only the monitor that is directly connected can receive the call.
- Only one relay can be opened.
-Auto switch-on on the monitor (Camera ON) may not be performed, only the video is activated when the call is
made from the panel.
Page 61