KEB Combivert F5 Instruction Manual page 69

Error Diagnosis
Display COMBIVIS
A. OL Warning ! Overload
A.OL2 Warning ! Overload 2
Warning ! Prot. rotation
A.PrF
forward
Warning ! Prot. rotation
A.Prr
reverse
A.SbuS Warning ! Bus synchron
A.SEt Warning ! Set
Warning ! Software limit
A.SLF
switch forward
Warning ! Software limit
A.SLr
switch reverse
Messages during the start-up phase
S.cc contactor closed
S.co contactor open
S.Ebd both directions
S.Ebr Error brake
S.io illegal operation
Other messages
idata invalid data
Va-
Meaning
lue
A level between 0 and 100 % of the load counter can be adjusted, when
99 it is exceeded this warning is output. The response to this warning can
be programmed.
The warning is output when the standstill continuous current is excee-
ded (see technical data and overload characteristics). The response to
100
this warning can be programmed. The warning message can only be
reset after the cooling time has elapsed and A.nOL2 is displayed.
The drive has driven onto the right limit switch. The response to this
94
warning can be programmed.
The drive has driven onto the left limit switch. The response to this war-
95
ning can be programmed.
Sychronization over sercos-bus not possible. The response to this war-
103
ning can be programmed.
It has been attempted to select a locked parameter set. The response to
102
this warning can be programmed.
The target position lies outside of the limit defined with the right software
104
limit switch. The response to this warning can be programmed.
The target position lies outside of the limit defined with the left software
105
limit switch. The response to this warning can be programmed.
143 Contactor control input not reset
141 Setpoint selection without contactor control input
144 Both directions of motion actuated simultaneously
142 Brake does not release
140 Setpoint selection without control release
Adjustments unknown. Select correct adjustment with "Up/ Down"
keys.
GB - 69